For a Christmas Tree: If youre looking for a giant bow to place atop your Christmas spruce, youll just want to double the maken process above to create a fuller effect.
Close the set with the shortest piece of make tape and fix it in the same way.
Click thumbnail to view full-size To make an overhand knot, form a loop.
For an asymmetrical bow, cut the maker ribbon on the same side of maker the book.
Wrap ribbons around gift so they twist around one another and then run perpendicular to eclairs the original direction.
Watch: How to Tie a iphone Present-Worthy Bow.
Let the tails trail down to the desired length.Cut a make small piece of ribbon just long enough to wrap around the middle of the ribbons.This wire helps the bow maintain its form.If you used wired ribbon, you can bend the loops out a little to make maken them look more full ribbon and rounded.If you want a symmetrical bow with the same number maker of loops on its right and left sides, cut the ribbon opposite from its starting point.If you make them too tight, youll have a hard time getting your bow to look like anything eclipse other than a round puff.Use a large bow as Christmas ribbon tree topper.Cut the base ribbon (non-wired) roughly 5 long (or longer for a larger gift) and cut notches at each end of the ribbon, by folding each end of the ribbon lengthwise and cutting eclipse a 45 degree angle upwards toward the center of the ribbon.Dont be afraid to start over if you realize you need to make your bow larger or smaller.For a large bow, tails of a foot or more look good.